Just In Case (My Pod)

At home or on the go, this discreet vibrator set takes you to unexplored heights with 7 thrilling functions, then lets you enjoy the rest of life’s pleasures. The included case not only recharges the bullet vibrator, it also sanitizes so you’re ready to play again anytime. You never know where your amorous adventures might take you so slip this set into your bag, just in case.

FEATURES

· UV sanitize and
recharge your toy at the same time
· Case
lights up inside when it sanitizes while the indicator lights on
the outside of the case show charging progress
· Case
holds two full charges—wirelessly recharge your vibrator on the go
· Smooth,
ABS bullet with 1 vibrating speed and 6 pulsing patterns
· Bath-friendly
toy, do not allow case to come into contact with water
· Run time: 40 minutes/hours
(high)
to 50 minutes/hours (low), charge
time: 2 hours
· Case: length: 4.5 in./11 cm, width: 2.25 in./5.5 cm
· Bullet: length: 3.5 in./9 cm, width: 1.25 in./3 cm
Contents:
· Just In Case Vibrator
and Case Set
· USB Charger Cord

DIRECTIONS

This
product arrives partially charged. Before use, charge completely.



Charging
the Vibrator: Place
vibrator into the case and close the case lid. Lights will illuminate and flash
while product is charging. Number of lights illuminated reflects current
battery power level. When product is fully charged, lights will stop flashing
and remain illuminated. Your case holds two full charges for your vibrator for
convenient, wireless charging on the go.



Charging
the Case: Use
USB power cord provided and insert charging pin into the opening on the back of
the case, then plug the other end into a USB port. Close case lid. Lights will
illuminate and flash while product is charging. Number of lights illuminated
reflects current battery power level. When case is fully charged, lights will
stop flashing and remain illuminated.



UV
Sanitizer Information: The case can also be used to sanitize the
vibrator. Before UV sanitizing, wash toy with clean water and Cleansing Mist.
Spray Cleansing Mist on the toy, rinse under running water, wipe clean, and pat
dry as needed. Toy must be completely dry before inserting into case. For UV
sanitization, insert vibrator into case and gently twist until the case cavity
light illuminates and remains solid. Solid light within the case cavity
indicates the UV sanitizer has activated. If the light is flashing, the
vibrator is not aligned inside the case. Close the case lid and wait 20 minutes
to complete a sanitization cycle. Do not open
the case before the cycle is complete as this will interrupt sanitization. If
the case is accidentally opened before the cycle is complete, close the
case lid to restart the cycle.



Using
the Vibrator: To
turn on, hold button for 3 seconds. To cycle through vibrating speeds and
pulsing patterns, push button. To turn off, hold button for 3 seconds.



Wash
before and after each use. For best results, use Cleansing Mist.